SOFTwarfare.AI
Nuclear · Oil & gas · SCADA · OT

Nuclear, oil, gas and energy

Identity and AI for nuclear plants, pipelines, and the SCADA, ICS, and OT networks that can't tolerate cloud latency or depend on a back-haul link.

The operational challenge

Pipelines, well pads, refineries, and substations run on isolated control networks and decades-old protocols. Shared operator logins and vendor remote access are common, and a cloud-dependent MFA prompt is useless when the satellite link drops. Investigations mean pulling historian data, PLC logs, and camera footage by hand.

The SOFTwarfare.AI answer

  • QuantaSeek® in the control center. Ingests raw log streams, sensor telemetry, and physical security feeds at byte level, and answers questions in seconds without data leaving the site.
  • Air-gapped Zero Trust Identity. Continuous biometric and behavioral verification for operators at HMI consoles and engineering workstations, with no cloud connection.
  • Machine identity for OT assets. Device fingerprinting and continuous verification for controllers and gateways, through PangaeAPI with no custom code.
  • Vendor remote access you can end mid-session. Risk-based termination when a third-party session drifts from its approved scope.
Energy solution briefQuote via WWT
Recommended bundleQuantaSeek® + Zero Trust Identity Mission edition
DeploymentOn-prem, air-gapped control network
IdentitiesOperators, engineers, vendors, PLCs, gateways, AI agents
Program alignmentDesigned to support NERC CIP, ISA/IEC 62443, and TSA pipeline security programs
Starting investmentQuantaSeek® quoted per mission; Zero Trust Identity® Mission edition $8.75 per operator per month
Request the energy brief

Use cases

Broad enough to fit your environment, specific enough to start a pilot next month.

Nuclear

Control room operator assurance

Continuous biometric verification for reactor operators and shift turnover, with walk-away locking on every console.

Pipelines

Remote compressor and pump stations

Verified technician access at unmanned sites over satellite or cellular links, with no cloud dependency.

Upstream

Offshore and field SCADA

Identity that works on rigs and well pads when back-haul is intermittent or gone.

Vendors

OEM and integrator access

Time-boxed, scoped maintenance sessions that expire automatically.

Investigations

OT incident reconstruction

QuantaSeek® correlates historian data, PLC logs, badge events, and video in seconds.

Grid

Substation and renewable sites

Physical and digital access governed together at substations, solar, and wind farms.

QUANTASEEK®A SOFTwarfare AI Fusion Platform
QUERYREMOTE NPU SEARCHNPU TELEMETRYISAAC
LENS OT Signal Intelligence
Which compressor stations saw remote logins outside a maintenance window this week?
Three stations match. Two logins used a vendor account with no open work order.
  1. CS-14 (West lateral): vendor login 02:11, no work order, setpoint change on unit 2.
  2. CS-09: engineer login from a new device, verified by biometric step-up.
  3. CS-22: repeated failed logins, then success from the same IP. Session terminated.
DATA PROVENANCE
Sources the NPU surfaced for this answer.
HistorianCS-14 unit 2 discharge pressure setpoint 812 → 860 psi
Remote access logvendor-acct-07 · 02:11 · no ticket
Work ordersCS-14: none open
Badge systemCS-22 gate: no entry recorded
CONFIDENCE91%
FABRIC HEALTH88%

Illustrative, sample data.

Physical security

Protected areas, SMRs, and microreactors

Fence sensors, cameras, gates, and badge readers feed the same command layer that protects your control systems. An intrusion at the perimeter steps up access to the OT network automatically.